Two Simple Ways to Maintain Your Water Heater

For many households, the water heater is a very important equipment. The Water Heater’s function has become a very large part of their day to day living, without them noticing it. Having hot water makes it bearable to bathe early in the coldness of the morning, hot water makes it easier to clean the house, and so much more. 

Our water heaters, however, like other things and machines would encounter mechanical problems, such as slab leak, and would sometimes fail. This failure of our water heaters impedes the way we want to live our lifestyles. With this said, it is very important to maintain our water heater. To help you, here is a simple guide on how to maintain water heater by yourself. 

  1. Safety First

Water Heaters involve electricity, as well as other forms of fuel like gas. If you are afraid of handling these things because you have no idea on how to handle them, then it is better to leave the job to the professionals. You should also always wear protective gears like goggles, gloves, and other equipment. If you suspect that your water heater has problems beyond basic maintenance, then contact water heater repair. 

  1. Inspect the Pressure and Temperature Valve

The pressure valve is one the most important components of your water heater, and so, you should begin inspecting it first. The function of the pressure and temperature valve is that when both of this factors go exceedingly up, then the valve opens and releases the temperature or pressure to bring the water heater back to equilibrium. If the valve is broken, there is a tendency that the water heater would burst. 

To check its condition, first turn off the fuel source of electricity or gas, and also the water inlet of the machine. Next is to prepare a bucket and place it on the floor below the valve. Next is, pulling the lever of the valve, and if your valve is functioning properly, you should hear a hiss of small amounts of air and the presence of water vapor. If this doesn’t happen, your valve is broken, and you have to replace it immediately with a valve of the same size and kind. 

  1. Flushing of the Tank

Flushing the entire water content of your water heater is also one of the best ways to maintain the good condition of it. When water is stored long enough in the tank, there is a possibility that it will develop sediments. These sediments affect the efficiency of the heating capacity, and it accumulated, it can block off passageways of the water heater.  

To flush the tank, first turn off the water heater off. Then you can proceed by obtaining a water hose and connect it to the draining component if your water heater. Make sure that the end of the water hose is placed in a place where hot water doesn’t damage anything. Release the pressure valve and the drain valve, and wait for the water to drain completely. After draining it completely, close all the valves and refill the tank. 

However, there will be times when you will need a help from a professional. So, if that time comes, it is best if you have a contact. You could always get one if you visit their website, such as http://www.jcplumbinggreen.com.  

Read More